Windshield Glass Weatherstrip (needed to seal glass, aftermarket reproduction) ,
fits Corolla Coupes TE27, KE25, 9/70 to 7/74 Has groove for insert trim. $69.25 each.
Windshield Glass Weatherstrip (needed to seal glass, aftermarket
reproduction), fits Corolla Coupes TE27, KE25, 9/70 to 7/74
No groove for insert trim. $195.00 each
Front Windshield Glass Weatherstrip (needed to seal glass) aftermarket
reproduction, has groove for insert trim.Corolla 8/73 to 7/74
KE20, KE26, TE20, TE21, TE28. $
Windshield Glass Weatherstrip, (needed
to seal glass) fits Corolla Coupes TE27, KE25,
9/70 to 7/74. (has
grove for trim
Rear Windshield Glass Weatherstrip, (needed
to seal glass, come with the groove for the insert trim)
Corolla coupe 8/72 to 7/74, KE20, KE26, TE21. $212.50
Insert Trim, Chrome
, Aftermarket (cut
to fit) Plastic chrome insert trim, universal kit.
Enough to do one rear or one front windshield. $49.00
originals are long discontinued This is a popular
aftermarket alternative. With this trim, you
eliminate the "L" shaped corner pieces, because
ours sits a little higher than the original. Cut
to length and butt fit in the corners. If needed. We
recommend using a little black or clear silicon
adhesive in a tube (available at any parts or
hardware store) upon installation to ensure it
stays in place at speed.
Insert Trim, in black rubber. Same trim as
above, but for an all black look! $47.79
Liquid Sealer in a
caulk tube. A MUST
for proper sealing of front and rear Windshield / Windscreen
glass weatherstripping rubber. Must be use this to
insure long life against leaks. (can be used with any standard
caulk gun dispenser) . $19.62 per tube.
Glass Window (pop-out) Weatherstrip.
KE25, TE27, TE25. Sold by the pair. $230.85
to Hood (a.k.a. bonnet) Seal, (aftermarket reproduction) Corolla
Coupes TE27, KE25 (You have to make your own holes
for the clips included) $26.60
fits Corolla sedan,
TE21, KE20 (aftermarket) $136.05
fits Corolla coupe, KE25, TE27. $95.77
reproduction) fits Corolla Coupe TE27, KE25 (sold in pairs, left and right) $167.56
reproduction) fits Corolla KE20, KE26 (sold in pairs, left and
right) $97.62 pair.
reproduction) fits Corolla
Coupe 8/73 to 7/74 TE21, KE20, KE26,
door, $89.00 pair.
Door Seal, Rear
(aftermarket reproduction) fits Corolla
Coupe 8/73 to 7/74 TE21, KE20, KE26, 4 door sedan, wagon.
Front Corolla 3/72
to 7/74 KE24, TE27 (goes around entire door itself) $39.67
Door Glass Belt molding, Inner,
Corolla 5/70 to 7/74, KE2#, TE2#
(out side trim with rubber
strip at the top of the door that contacts the door glass
like a squeegee when it goes up and down).
Door Glass Belt molding, Outer
(aftermarket), fits Corolla Coupes TE27, KE25,
9/70 to 7/74 $35.00 each. Special order.
Door Glass Belt molding, Outer
Corolla 5/70 to 7/74 KE20, TE21, Standard model (out side trim with rubber strip
at the top of the door that contacts the door glass like a
when it goes up and down). $23.71 each.
Exterior / Body
Fiberglass Body Parts:
All of our fiberglass body parts are of
the highest quality available. Completely bolt in, with all
the proper bolt holes and threads in their exact positions as
Special order. These are made by our manufacturer in Japan.
They are made to order and take about three weeks to produce
before shipping direct.
/ a.k.a Bonnet (Fiberglass reproduction, ships
direct from Japan) Corolla TE27 $490.36
Lid / a.k.a. Boot (Fiberglass reproduction, ships
direct from Japan) a.k.a. boot, Corolla TE27 $352.98
(Fiberglass reproduction, ships direct from Japan) left
and right sides Corolla TE27 $980.59
Flairs / Over Fender, Set of 4.
Front (Fiberglass reproduction, ships direct from Japan)
Corolla TE27 $284.00
Rear (Fiberglass reproduction, ships direct from Japan)
Corolla TE27 $284.00
Hood Adjustable Rubber Bumper,
Corolla KE25, TE27,
9/70 to 7/74 The hood rests on
these when closed (2 required).
Replace your old worn out and cracked ones! $14.45 each.
Antenna Replacement Kit
pillar mount $29.76 Click
Here for more info
Replacement Kit fender mount. This antenna is
telescoping (3 sections). 38 inches extended. $24.50
Popular! Classic Side View Mirror Sport Set
. These after
market mirrors have the Classic sporty styling that your classic
Similar design to factory-original sport mirrors at a fraction
of the price. They come in black and chrome and look great !!! Click
for Street and Racing. Click Here.
Drive Cable (goes from
transmission to back of speedometer makes M.P.H. needle work)
Levin, coupe and wagon, TE21, TE27, TE28, KE20, KE25, 9/71 to
Will fit left or right hand drive cars (Limited quantity
in stock) $219.45
Pad Restoration Kits, Check
them out!!! Click Here
, standard replacement. $4.60 each
, upgraded brighter Light-Emitting Diode
(LED) Sold by the pair. $23.82 pair.
Switch Corolla 1972-74 (part behind the ignition lock and key) switch, wires and
Clutch Foot Pedal Rubber Cover, fits many Toyotas with manual transmissions from
1970 on. $13.00 each.
Interior Door Handle Bezels
( hard plastic goes around
inside door handle, usually crack), TE27, KE25, KE20
$19.94 in Black Color
Complete Carpet Set, Sewn (Aftermarket)
request color needed. $348.00
This is a five piece set. 3 for the front and two for the rear.
Designed like the OEM carpets in many early 1970's cars.
When all installed the carpet looks great!
NEW! Toyhead Auto
Professional Carburetor Rebuild Services
Rebuild Service For
All Toyota Starlet Carburetors
Price includes return
shipping in the U.S.A.
Send in your old carburetor to be professionally rebuilt to
look and run like new.
Comes with a 90 day
For Carburetor Rebuild Services Above
Please Contact Us At :
Sending Unit / Float (for fuel gauge) aftermarket,
mounts inside fuel tank. $110.00
Electric Fuel pump After market. Mounts externally, comes with instructions (fuel pressure 4.5 pi out put) A low cost alternative to replacing the original fuel pump $56.42
Coolant Overflow Reservoir Kit
Aluminum Racing Radiator
for Corolla 71-74
Fan Kit. Free Up Horse Power!!! This electric fan kit come with a
high efficiency fan design, fan motor and all the hardware to
Get about 3-6 extra
HP by eliminating the original, heavy belt driven clutch fan
just by installing this kit.
Can be wired up to operate manually or automatically with the
additional kits listed below. Price $120.78
Thermostatic Fan Switch
for above fan kit. Automatically turns on fan when engine
temperature reaches 185 degrees Fahrenheit. $56.20
Thermostatic Fan Switch
. Same as above but can be
adjusted to switch on from 160 to 240 degrees Fahrenheit $92.90
Electronic Conversion Kit
NEVER CHANGE POINTS AGAIN! Saves gas and extends the
life of your spark plugs. Come with a magnetic pick up
you screw inside the distributor.
eliminates the unreliable points that ware and constantly change
the ignition timing. With this kit you just set it and
forget it!!!! Its is easier to install than as a set of
points but you only do it once! Entire ignition system fits beneath
distributor cap to maintain original look. No alteration
to distributor required.
A REAL GAS SAVER!!! SMOG Legal in 50
This unit replaces
and eliminates the igniter assembly unit that is located on
top of the ignition coil
and give a better more
powerful spark at any rpm and better gas millage too!
Whether you have a powerful street machine, daily stock driver
or trick Street Rod, the multiple sparks of this ignition unit
will ensure complete combustion. Bolt one on and look for
quicker ETs, easier starting, reduced plug fouling, quicker
revving, more power and increased fuel economy. This unit can be triggered
by breaker points, magnetic pickup, or the output of an
Please note: To get the
full benefit of this unit we highly recommend using the
blaster ignition coil listed below to replace your old stock
Box, Multiple Spark Discharge Ignition System With Rev
as unit above, but with engine saving maximum RPM rev limiter
that could be adjusted to any rpm.
Please note: To get the full
benefit of this unit we highly recommend using the blaster
ignition coil listed below to replace your old stock coil.
Ignition Coil Upgrade
15,000 more volts than stock.
Blaster coils put out 45,000
volts, which are 15,000 more than stock.
They also have an oil filled metal canister and will fit stock mounting
Suspension and Steering
NEW!!! Steering Wheel Adapter/Boss Kit $52.00
This kit allows the use of many aftermarket steering wheels.
Coil Springs, suspension standard height springs and high performance lowering springs for street and racing.
For Corolla 1970 to current year (front or rear). Click here for more information.
NEW!!! Performance Street/ Race Front Strut Cartridge Inserts, Corolla TE27 Chassis. $272.35 pair
Much better performing upgrade for better control, handling and safety over originals.
Fits RA20, 21, 22, 25, TA20, 22, 23 27 Chassis.
NEW!!! Performance Rear Shock Absorbers Street / Race, Corolla TE27 Chassis. $206.67 pair
Gas filled, Stiffer performance for high speed.
Front Control Arms Rebuild Kit. Includes 2 quality heavy duty ball joints with serviceable grease fittings
and upgraded polyurethane control arm bushings with steel center tubes to do both front control arms. $124.17
Front Strut Mounts Corolla 1970 to 1981 $62.67 each.
Pitman Arm (Steering) Corolla 1970 to 1974 $61.76
Wheel Bearing / Front Hub Kit. These are the two bearing that mount inside the front rotors. One kit does one side of the car. Contains inner and outer bearings. $37.91
Upgraded Aftermarket High Performance Polyurethane Chassis / Suspension Bushings.
Save money, cheaper than buying original type bushings!!! Better than the originals and last forever.
For your daily driver or racer. Upgrade those old worn out, dry rotted rubber bushings to better the ride, handling and safety of you vehicle. Click here for pricing or to inquire.
New!!! Windshield Washer Reservoir Bottle Kit Complete (aftermarket) $108.00
Starter (rebuilt) all motors $70.00*
* A $20.00 core charge must be added to the price and is refundable in exchange for your old starter.
For 2TG Engine Parts. Click Here
Timing Gear Complete Set for 2T, 2TC, 2TB motors Includes Camshaft Sprocket, Crankshaft Sprocket, Oil Seal, New tensioners,
Guide Rail, Gaskets (not shown) and timing Chain. These are high quality sets for running long and hard.
Exhaust Pipe Flange Gasket Corolla 1971 $8.50
Oil Pump for Corolla 2TC, 3TC Engine $171.60
Brakes / Hub
Wheel Bearing Cap / Bearing Dust Cap $9.76 each.
Brake Master Cylinder Rebuild Kit Corolla 1971-74 $45.00
Brake Master Cylinder Corolla 8/74 to 8/79 1.6 2TC motor $65.58
NEW!!! High Performance Drilled and Slotted Rotors. $135.00
Great for street or race. Big improvement in braking.
Brake Hardware Kit, for the front disk brakes $25.50
Differential Pinion Seal (Seal behind flange
where the drive shaft mounts) $19.24
Rear Differential Carrier Bearings and Race/Cup $114.00 set of 2
Rear Differential Pinion
Bearings and Race/Cup Set
of 2 inner and outer $79.18
Axle Seals $15.81 pair
Shaft Bearing Rear (out side bearing near tire)
We do business by email!
*Prices do not
If you would
like a price quote with shipping please send your zip
with a list of item you are interested in buying.
Send Email to: email@example.com
We accept all major Credit Card payments through PAY PAL.com ONLY.
It is the #1 online payment service in the world.
They are safe, secure and the
fastest way to get items paid for instantly and shipped to
Through Pay Pal we can receive payments in over 23
Paying is easy. We can send an invoice via email through
Pay Pal, the email-invoice will take
you through the easy steps to pay instantly online with a
few clicks. It does not cost anything to sign up.
See them at: https://www.paypal.com/
WE SHIP WORLD WIDE !!!
Please contact me by email for
any additional questions regarding other payment options
Thank you for visiting
Toyhead Auto Parts!
The best way to contact us
is by email !!! Send Email to: firstname.lastname@example.org